Representative costs for replacing a dishwasher control board typically include the part price and labor. Main cost drivers are the board type, brand compatibility, and whether diagnostic labor is required. The following estimates help buyers budget for a repair rather than a full replacement.

Assumptions: region, specs, labor hours.

Overview Of Costs

Typical ranges for a dishwasher control board replacement span roughly $210 to $700 total, depending on part type and labor. Part costs usually occupy $120 to $420, while labor can run $90 to $260. In some cases, a diagnostic or troubleshooting visit is billed separately. Parts sourced from the original equipment manufacturer (OEM) tend to be at the higher end of the range, whereas aftermarket boards can be cheaper but may affect fit or reliability.

Cost Breakdown

The table below summarizes common cost components for a control board replacement. The figures assume standard kitchen-duty dishwashers and typical service call practices.

What Drives Price

Board type and compatibility are primary drivers. Main control boards are more expensive than simple display boards. Some models require a specific wiring harness or adapter, which adds cost. Brand and model complexity also influence price, with high-end or compact units often needing more specialized parts. For example, premium brands may incur 20–60% higher parts costs compared to basic brands, even when labor is similar.

Other notable cost factors include diagnostic time (if the technician must trace an intermittent issue), wiring harness replacements if damaged, and availability of the exact part. In rare cases, a board failure indicates underlying motherboard damage or motor controller issues, increasing both parts and labor.

Ways To Save

To control expenses, buyers can consider comparing OEM vs aftermarket boards for fit and warranty terms. Some manufacturers offer remanufactured boards at a lower price with a limited warranty. Scheduling repairs during off-peak hours or seeking quotes from multiple technicians can yield savings. In certain regions, flat-rate service plans cover diagnosis plus components for a single price, reducing surprise bills.

Regional Price Differences

Prices for dishwasher control board replacement vary by region due to labor markets and parts availability. In the Northeast, expect the average total to trend toward the higher end, roughly 5–15% above national averages. The Midwest typically aligns with national averages, while the South and West can be 0–10% higher depending on urban vs. rural access to parts. Regional variation can affect both part pricing and hourly labor rates.

Labor & Installation Time

Typical install time ranges from 1 to 3 hours. Labor rates commonly fall between $90 and $160 per hour, depending on technician experience and local market. data-formula=”labor_hours × hourly_rate”> A straightforward board swap on a standard unit often lands in the 1.5–2 hour window, while more complex models or hard-to-access locations may exceed 2.5 hours.

Real-World Pricing Examples

Three scenario cards illustrate common outcomes. Assumptions: mid-range model, standard wiring, no additional repairs.